Messages

11

General Mach Discussion / Re: FREE Router.

« on: February 09, 2010, 12:14:55 PM »

How dose a guy contact them to see if it is still avaible
   klmark

12

General Mach Discussion / Re: z+ z- move

« on: November 05, 2009, 02:36:52 PM »

Well that is all I can help that is how I us it I like to fine tune on ever z plung

13

General Mach Discussion / Re: z+ z- move

« on: November 05, 2009, 12:01:41 PM »

Also do a search of ( Jogging Z axis while machine is cutting ) that will help you on this forum

14

General Mach Discussion / Re: z+ z- move

« on: November 05, 2009, 11:58:35 AM »

No I will help anyway I can Go to config ports and pins input signals  in input signals stroll the to  THC UP and THC down  enable both enable Emulated then set a hotkey for up and down this will control your up and down with the keyboard hit apply and go to Mill Options check mark Allow THC UP/DOWN Control even if not in THC mode hit apply and OK your ready to go

15

General Mach Discussion / Re: z+ z- move

« on: November 05, 2009, 09:42:46 AM »

Yes it is possible I do it all the time on my flame torch If I understand right you want to fine tune the z Axis while running g code

16

General Mach Discussion / Re: Plasma Application, Mach3 torch height control.

« on: November 04, 2009, 05:49:19 PM »

Hey guys
 Did you get your DTHC working

17

Tempest Trajectory Planner / Re: Tempest Planning - Preliminary information and testing

« on: September 26, 2009, 05:33:39 PM »

Hi Art
 Just tryed 25-1 it seems to work pretty good my Z axis just dose not work the way it should I don't know if it's the software or settings on the machine running the same g code switch back to ruagler Mach it runs alllright    Thank you   

18

Tempest Trajectory Planner / Re: Tempest Planning - Preliminary information and testing

« on: September 25, 2009, 06:01:39 PM »

Hi Art
 First I am probable doing it wrough When I go to Config- Select planner type- and check mark use tempest planner that is when the problems show up and the machine dose do the circle instead of just the arch 

19

Tempest Trajectory Planner / Re: Tempest Planning - Preliminary information and testing

« on: September 25, 2009, 11:11:34 AM »

Hi Art
Attach is a file you could test which I get weird stuff happing try it see if it runs alrihkt on your machine if I do circles or arch the Z axis moves up and down when runing G code    Thank you

20

Flash Screens / Re: Can't get Mach Nation to work

« on: June 04, 2009, 04:18:13 PM »

Thank you that will be great
  Klmark