Guest
Show Posts
11
General Mach Discussion / parallel port inputs work, but outputs dont unless restart computer?
« on: September 19, 2011, 09:19:37 PM »
I tried searching for this, but had no luck, and as Im not sure what to search.
I switched computers awhile back, system was all working fine, but computer needed upgrading. Now using a Dell Dimension 3000. Everything works fine now, except it seems that if the computer sits long enough without me using it (not sure how long that is, or if its when it sleeps and wakes or what) I start mach 3 to cut something and i go to jog the motors, and the DROs show movement, but the motors do not move. I can see limit switches being switched on the diagnostic page if I push them, thats what gets me. Its kinda like Mach sees the inputs on the port, but isn't sending the outputs.
It can all be solved by restarting the computer, but I need to figure out why so I dont have to restart everytime I want to use it.
I have the onboard Parallel port in Epp mode and then a pci double port card (used without any problems in the old pc) (although with the mill, I am only using the onboard port 1 at the moment) The PC has a 3.2 ghz processor in Hyperthreading mode, and 2 gigs of ram running 400mhz dual channel.
Any ideas?
Thanks,
Brian =)
I switched computers awhile back, system was all working fine, but computer needed upgrading. Now using a Dell Dimension 3000. Everything works fine now, except it seems that if the computer sits long enough without me using it (not sure how long that is, or if its when it sleeps and wakes or what) I start mach 3 to cut something and i go to jog the motors, and the DROs show movement, but the motors do not move. I can see limit switches being switched on the diagnostic page if I push them, thats what gets me. Its kinda like Mach sees the inputs on the port, but isn't sending the outputs.
It can all be solved by restarting the computer, but I need to figure out why so I dont have to restart everytime I want to use it.
I have the onboard Parallel port in Epp mode and then a pci double port card (used without any problems in the old pc) (although with the mill, I am only using the onboard port 1 at the moment) The PC has a 3.2 ghz processor in Hyperthreading mode, and 2 gigs of ram running 400mhz dual channel.
Any ideas?
Thanks,
Brian =)