Messages

21

General Mach Discussion / Re: Switching computer woes

« on: September 01, 2011, 02:25:33 PM »

No change. I get one quick flash of "Excellent system stable" followed by "Pulses too fast"

Windows 7 is the operating system.

Brian

22

General Mach Discussion / Switching computer woes

« on: September 01, 2011, 01:29:00 PM »

Hi,

i have been running mach3 for several months, My computer is on it's last leg. I am trying to replace it similar performance but newer machine. The new machine has no parallel card so i bought the Roswell from newegg that was linked in a previous thread, installed it with the linked driver from the chipset manufacturer. I also copied my XML file from the old machine to the new install.

I have no output from the parallel card to the G540, I checked with meter on the pins, Also checked the parallel card with a LED driver program and it works, the address in Mach is set to the same one that works with the LED driver program. When I run driver test I get "pulses to fast". What is it telling me?

I am not a computer guy, I prefer to hit things with a hammer.

Any advise?

Brian