951
Mach4 General Discussion / Re: Mach 4 install problems with smoothstepper
« on: February 15, 2015, 11:20:43 PM »
bronk i see you have x as 0 & 1 you sure
it should be X = 0, Y = 1, Z = 2 if you have a slave for x it should be 3, 4, 5, so on.
inputs and outputs will only save for motion device selected be it sim, ess what ever have you looked through the new ess manual settings are the same just different place.
I will be have a go at connected my ess up to M4 next week.
can you wack up a screen shot of your settings page by page
it should be X = 0, Y = 1, Z = 2 if you have a slave for x it should be 3, 4, 5, so on.
inputs and outputs will only save for motion device selected be it sim, ess what ever have you looked through the new ess manual settings are the same just different place.
I will be have a go at connected my ess up to M4 next week.
can you wack up a screen shot of your settings page by page