Messages

891

Mach4 General Discussion / Re: Mach4 / Darwin setup

« on: April 14, 2015, 10:25:54 PM »

well that looks really good incress to 25000 see what happens, it shows that it`s connected it all looks correct is there something that your bob needs a setting like charge pump

892

Mach4 General Discussion / Re: Mach4 / Darwin setup

« on: April 14, 2015, 08:57:11 PM »

when you go into Darwin what does the water fail put out put up a screen shot of it

893

Mach4 General Discussion / Re: Mach4 / Darwin setup

« on: April 14, 2015, 12:12:07 AM »

don`t ya hate when that happens

894

Mach4 General Discussion / Re: Mach4 / Darwin setup

« on: April 13, 2015, 12:17:31 AM »

you need to restart the computer in between loading M4 and Darwin then when you select Darwin as the driver restart M4 then do the settings in darwin restart computer do the settings in M4 then restart M4 then it should be all good just remove sim after you first load M4 before restart and remove M3, M4, M5 macros from macro folder.

other than that it should work unless the address for the pp is wrong most times it`s 0x328

895

Mach4 General Discussion / Re: Mach4 / Darwin setup

« on: April 12, 2015, 11:23:13 PM »

yes that is a bug some people get when you enter info in the config or just go into the config you have to reset and re enable to get thing`s working again.

barr553 you may need to go into c/ drivers and remove the Darwin driver when you remove everything quite often it gets left behind when you remove everything and when you re install everything back in it can make it go silly.

also only have Darwin as a driver in your plugin folder sim can make Darwin not work at all.

there is a newer version of Darwin you will have to ask art for it

896

Mach4 General Discussion / Re: Mach4 / Darwin setup

« on: April 12, 2015, 09:11:43 PM »

quite often you need to restart M4 for the changes to stick other wise you will have to do above but that may not make the changes stick so your better off restarting M4

897

Mach4 General Discussion / Re: Mach4 / Darwin setup

« on: April 11, 2015, 07:25:52 PM »

put up some screen shots

898

Mach4 General Discussion / Re: Mach4 / Darwin setup

« on: April 10, 2015, 06:02:27 PM »

you need to make sure you motor are set to motor o as x, motor 1 as y, motor as z in Darwin and M4

899

Mach SDK plugin questions and answers. / Re: 5 axis kinematics coming soon !!!

« on: April 09, 2015, 01:56:43 AM »

dude that really cool you just need to do it for M4 now

900

Mach4 General Discussion / Re: Mach 4 Bug Reports

« on: April 05, 2015, 08:51:12 PM »

you will need a script to do it in M4