Hello Guest it is March 28, 2024, 10:10:37 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dude1

811
you would have to ask poppabear and Ya Nvr No reading through there post it looks like they have worked it out dazthegas may have as well as far as I can see its using the call for that function, I got probe input working with a button all I did was map a input to it

812
Mach4 General Discussion / Re: Mach4 & ESS Setup Problems -
« on: May 15, 2015, 07:35:05 PM »
he should of that's what I told him to do

813
Mach4 General Discussion / Re: Mach4 & ESS Setup Problems -
« on: May 15, 2015, 06:28:51 PM »
As for my spindle, I removed the files M3, M4, M5 from the Macros folder and I was able to turn on the spindle via MDI (M3 S2500 but, no speed control.
add a zero to what you have put in on motor speed page

I then set the configuration up with the help of daniellyall (thanks). However, I still do not have speed control or M4 (CCW). Maybe I am missing something in the ESS config? I have tried multiple selections with no luck.
you need to add a button to the screen the code is the same as for M3 you just change the 1 to -1

Spindle works fine with Mach3 under PWM settings

I have provided two pics and a PDF of the wring from the inverter. Hoping this will help.

Thanks
RCR
[/quote]

814
it can be done you just have to get the codes in the correct spot`s that's the really hard part of lua and M4

815
yep using a old keyboard saves money and works many different ways

816
tim you are using the same hardware as daz

817
Mach4 General Discussion / Re: LuaExamples
« on: May 15, 2015, 07:56:05 AM »
are you using it in sim or with your machine I havent been able to test on my machine its computer is on another machine else where

818
thanks man its going to be a big help to everyone your the man

819
General Mach Discussion / Re: advert blocks on Mach3 site
« on: May 15, 2015, 07:39:32 AM »
yer I think they are keeping on doing it the top bar keep`s changing where stuff is and what works more than likely to take M4 whats been done already and cracked A HOLE`S

820
General Mach Discussion / Re: advert blocks on Mach3 site
« on: May 15, 2015, 03:38:44 AM »
some wanker probley hacked it for fun