Hello Guest it is March 28, 2024, 09:38:00 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dude1

671
I thought you were a Kiwi dan? or an aussie?

I am no Aussie. I am a kiwi bro grr

672
Mach4 General Discussion / Re: need a little bit of help
« on: June 11, 2015, 05:32:04 PM »
look at page 2 of this thread

673
Mach4 General Discussion / Re: Mach4 Homing & Darwin Issue
« on: June 11, 2015, 05:29:23 PM »
you may have home in place set

674
Mach4 General Discussion / Re: Custom Signal Event Handler?
« on: June 11, 2015, 05:27:01 PM »
I just find crazy axe (Screwie Louie) funny I cant help but add something silly

675
Mach4 General Discussion / Re: Mach4 Printer Port Discussions
« on: June 11, 2015, 05:23:06 PM »
that's because there is no licence

they give X amount of time for testing only if you wont it to run all the time you have to get a licence

676
General Mach Discussion / Re: Camtech Laser
« on: June 11, 2015, 05:00:04 PM »
I have gotten the one for M4 working it cost $100 to make the controller

677
na the torys

678
Mach4 General Discussion / Re: Mach4 Homing & Darwin Issue
« on: June 11, 2015, 06:31:42 AM »
have you tried dazthegas homeing code

679
if you have a look at what poppabear did it will show you

680
Mach4 General Discussion / Re: need a little bit of help
« on: June 11, 2015, 06:16:47 AM »
no it`s whats on page 2 it does not matter as it work`s and it wont crash or anything silly like that it`s just something that happens with the forloop