Messages

601

Mach4 General Discussion / Re: 2nd window

« on: July 15, 2015, 04:58:53 PM »

sent Josh a pm with your email

602

Mach4 General Discussion / Re: 2nd window

« on: July 15, 2015, 03:31:55 AM »

very good sl works very well

603

Mach4 General Discussion / Re: 2nd window

« on: July 15, 2015, 12:43:50 AM »

that look`s cool you should make a female friendly screen set hot pink

604

Mach4 General Discussion / Re: 2nd window

« on: July 14, 2015, 01:56:28 AM »

what no jack

605

General Mach Discussion / Re: Future of Mach3 ??

« on: July 13, 2015, 06:48:55 AM »

Mach 4 pp (Darwin) can do that to

606

Mach4 General Discussion / Re: Mach 4 Axis Calibration solution

« on: July 13, 2015, 01:20:30 AM »

yes it up to the people to use the thing between there ear`s if you wont put a note on it

     This will calibrate your machine only
Feeds and Speeds are up to you to double check

607

Mach4 General Discussion / Re: Mach 4 Bug Reports

« on: July 11, 2015, 06:12:59 PM »

 very true ger, I reproduced it hitting stop shifts the Zero over it did not happen with feed hold

608

Mach4 General Discussion / Re: Mach 4 Bug Reports

« on: July 11, 2015, 04:40:20 PM »

you should not be hitting cycle stop use Feed Hold 

609

Modbus / Re: arduino mega to mach3 prototype

« on: July 11, 2015, 04:20:11 PM »

you wont have the CRC library or it needs updated c/program files/arduino/hardwear/arduino/avr/cores/arduino

610

Mach4 General Discussion / Re: Mach 4 Axis Calibration solution

« on: July 10, 2015, 07:05:21 AM »

your bang on brett step per mean bugger all if your going to fast or the acc is to high or low

best way to do it calibrate, test over a 100 movements in what ever axis then slow down try again