Messages

61

General Mach Discussion / Re: converting from PDMX 411 to ESS and using g540

« on: November 14, 2017, 02:06:59 PM »

I posted the wrong link it was meant to be this one  https://warp9td.com/index.php/gettingstarted/setting-up-the-smoothstepper-and-mach4  

62

General Mach Discussion / Re: converting from PDMX 411 to ESS and using g540

« on: November 14, 2017, 04:01:28 AM »

You pretty much don't need to do anything other than connect them up set the ethernet up and the stuff it says to do on this page https://warp9td.com/index.php/faq/faq-mach3 and use the Gecko provided profile for the G540.

If you watch andy's videos he does a good job of walking you through what to do as well.

A lot of the stuff Andy has done in the last few years makes it quite easy to set everything up and get going in an hour or so, some parts are too easy now.

63

General Mach Discussion / Re: A-axis rotary lathe question for Mach 3

« on: November 11, 2017, 06:12:59 PM »

It over rights fine but backup your config file first

64

General Mach Discussion / Re: A-axis rotary lathe question for Mach 3

« on: November 11, 2017, 04:32:07 PM »

http://www.machsupport.com/software/downloads-updates/  then click on FTP downloads - FTP server Main menu - Mach3 - mach3 version 3.043.062 exe

65

General Mach Discussion / Re: This is just plain... WRONG

« on: November 11, 2017, 03:30:14 PM »

It's called the entitled generation, you see the same thing every where they don't wont to know how to do it, just that it is wrong and you will sort it for them.

There are a lot of people useing fusion like that they get help once if they try that ********* again they get told to RTFM and it's most times people under 30, a 30 year old gave me arsehole over me saying that 2 hours later he apologised and said I just had the same thing.

66

General Mach Discussion / Re: A-axis rotary lathe question for Mach 3

« on: November 11, 2017, 02:31:36 AM »

ftp://ftp.machsupport.com/Mach3/

67

Mach4 General Discussion / Re: Mach 4 and parallel port

« on: November 07, 2017, 09:33:34 PM »

Sage to me haveing to fluff around like that is a waste of time, I tried it and read the same thing at the time when I tried it.

68

General Mach Discussion / Re: A-axis rotary lathe question for Mach 3

« on: November 07, 2017, 09:23:34 PM »

https://www.youtube.com/user/Simpsons36/videos

69

General Mach Discussion / Re: A-axis rotary lathe question for Mach 3

« on: November 07, 2017, 05:41:24 PM »

PLC = https://en.wikipedia.org/wiki/Programmable_logic_controller

70

Mach4 General Discussion / Re: Mach 4 and parallel port

« on: November 07, 2017, 02:27:50 PM »

The charge pump does not work as you have found out so how many people useing the charge pump is more than likely 0. I tried the charge pump root it did not work.

even the dude that made the gecko g540 says to turn the charge pump off