Messages

561

Mach4 General Discussion / Re: External controls

« on: August 12, 2015, 07:44:51 PM »

if you have a look through the forum that has been covered

562

General Mach Discussion / Re: Mach 3 on Windows 10

« on: August 12, 2015, 01:08:10 AM »

you need to reinstall M3 and there plugs

563

General Mach Discussion / Re: Greetings@! New here and have question about compatibility

« on: August 10, 2015, 08:24:12 PM »

the router is a copy or the same as the machine I have, the one I got needed a lot of money and time spent on it and is still not that good, the machine from them it might be ok but if you wont a plug in and go with a 100% back up buy from close to home. it will be 50 / 50 if that is a good machine but if you can fix what may be wrong it may or may not cost almost the same as a close to home machine. its a risk you need to put in your bosses hand`s.

564

Mach4 Toolbox / Re: Saving the selected spindle speed range

« on: August 10, 2015, 06:30:21 PM »

write to .ini its in the scripting manual in the manual section of mach web site

565

Mach4 General Discussion / Re: Comments about Mach4 in Demo

« on: August 07, 2015, 08:37:32 PM »

with M4 its the simple things that go wrong (brain fart) a reinstall always helps if there is one silly little thing wrong just for fun if you goto http://machremote.dyndns.org:8080/ its mach help desk there is a probing screen set

566

Mach4 General Discussion / Re: Comments about Mach4 in Demo

« on: August 06, 2015, 03:41:05 PM »

I would say M4 has gone bad it will need reinstalled

567

Mach4 General Discussion / Re: Comments about Mach4 in Demo

« on: August 06, 2015, 02:27:56 AM »

yes but it dont look right

568

Mach4 General Discussion / Re: Comments about Mach4 in Demo

« on: August 05, 2015, 09:45:18 PM »

look in diagnostic/regfile/core/inst you can added them to a screen set as well they are they just not added

569

Mach3 under Vista / Re: Difficulties in testing gcode strings off line

« on: August 02, 2015, 05:08:37 AM »

you need to set up another copy of M3 on another computer so you can sim your code it works only with the motion controller as it will be looking for that when you try to sim some code.

or another way that might work set up another profile from scratch don`t copy the existing profile call it sim don`t load the motion controller plugin just have all the settings there just no plugin it may work that way.

570

Mach4 General Discussion / Re: Single Switch, Homing + Limits

« on: August 02, 2015, 02:06:57 AM »

if as bob say`s its the ESS ask look on the ESS forum there is a way around it, I don't know how well it works if, if the work around is still valid