Messages

551

Mach4 General Discussion / Re: The great screen debate

« on: August 24, 2015, 03:28:20 PM »

Chaoticone I here ya about nobs after a year or two most people stop using FRO, RRO so could you do a bask screen like yours minus MDI and have one like BR549 and I suggested, over here a touch screen is in $000 so that's a no go. simple is good (and forget the M3 look )

552

Mach4 General Discussion / Re: The great screen debate

« on: August 24, 2015, 02:16:37 AM »

attached image would be close to how I would like it just one more button added, all the main tools used everyday on one page is good. FRO, RRO moved to tab used 10 times in 4 years if that.

MDI page removed, every other page is fine.

also it would be good, to not have it look so fancy that is not important to me.

have more keyboard control of screen main tabs on F keys, the bit at the bottom on tab key to move from page to page,
have it so it`s tab or F to page hit enter to select page, then tab to move through page and enter to action or key`s pre set to commands I know you can do it now but more than what can be use now. like what can be done with pokey keyboard.

553

Mach4 General Discussion / Re: The great screen debate

« on: August 23, 2015, 07:35:42 PM »

I am with ger21

554

Mach4 General Discussion / Re: The great screen debate

« on: August 23, 2015, 06:58:21 PM »

program page yes,mdi page not needed others fine

555

PoKeys / Re: Mach4 V2 + PoKeys 57E

« on: August 21, 2015, 06:45:49 PM »

use what it says on there web site pokey version 7.8.1.2580 use M4 version 2580 the last 4 number are mach 4 version

556

Mach4 Toolbox / Re: Floating MDI Panel V1

« on: August 20, 2015, 06:04:23 PM »

well done daz works good

557

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: August 16, 2015, 10:14:10 PM »

 tweakie stuff is here or on his web site http://www.cooperman.talktalk.net/ I could not find what you are looking for ever

558

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: August 16, 2015, 06:44:19 PM »

http://gearotic.com/ESW/FavIcons/index.php?board=16.0

559

Mach4 Toolbox / Re: Saving the selected spindle speed range

« on: August 14, 2015, 06:51:55 AM »

your getting good at lua daz inst, val is the key

560

Mach4 Toolbox / Re: Saving the selected spindle speed range

« on: August 13, 2015, 06:01:08 PM »

have a look at this