Messages

511

Mach4 General Discussion / Re: Mach 4 licence not instaling

« on: September 08, 2015, 09:50:51 PM »

10 is better well it`s quite good no more silly ********* on ya screen and a hell of a lot better start icon left click or right click both work.

512

Mach4 General Discussion / Re: Mach 4 licence not instaling

« on: September 08, 2015, 09:26:14 PM »

yer but half of the user can`t afford to drop the dollars for a new computer or bits need

513

Mach4 General Discussion / Re: Mach 4 licence not instaling

« on: September 08, 2015, 08:17:32 PM »

there are some dependency that need to be added to M4 for it to work on xp

514

Mach4 General Discussion / Re: Mach 4 licence not instaling

« on: September 08, 2015, 06:10:25 PM »

well at lest they gave you the correct answer

515

Mach4 General Discussion / Re: Mach 4 licence not instaling

« on: September 08, 2015, 05:41:56 PM »

I found if I have A axis enabled it would not work but that`s not the problem.

one thing I found that helped was to reload M3 as it would over wright the driver`s on load up. then go back to M4 with only the E stop going then added in the axis`s close and restart M4 then do the other inputs, close and restart then do the outputs.

the ESS set up can be a nightmare to do if one setting is wrong. and 2651 was a op`s you have to go to the new one they made some mistakes in the code

516

Mach4 General Discussion / Re: Homing

« on: September 08, 2015, 03:26:10 PM »

your log shows homing axis letter and axis numbers at the same time if you home A axis only as motor 1 what happens, the motor numbers are the mapping function across all plugins`s Mach4 does not give a ********* what axis letter is set to a axis number as this is just the mapping of motor`s.

your problem is A axis so just run that by it self once you have done that a put up the logging, we can see what is going on with that motor then go from there

517

Mach4 General Discussion / Re: Mach 4 licence not instaling

« on: September 08, 2015, 03:18:11 PM »

how many Axis`s do you have set up

518

Mach4 General Discussion / Re: Homing

« on: September 04, 2015, 09:23:33 PM »

Chaoticone I see there is a new version out they have not got the test screen set you did for the default screen in it.

519

Mach4 General Discussion / Re: Homing

« on: September 04, 2015, 07:18:15 PM »

thanks Chaoticone did not think of that one.

KingKerf please try that

520

Mach4 General Discussion / Re: Homing

« on: September 04, 2015, 05:30:25 PM »

set all other axis to home in place, then run just the A mapped as Y with no code, then with your code keeping a copy of the log each time, doing that way will show if it can be done with out code and what does or does not go wrong. same with running your code.

then the code can be compared, everything has a order to it where that order goes wrong is what is need that`s why the logging is used to find where it`s going wrong.

on what was in the log you posted it showed something when`t wrong but it had the other axis in it and calling of your code you can see where the estop was hit but it carried on if you run the code what daz posted it will still put a log out even with it crashing