Hello Guest it is April 24, 2024, 07:31:44 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dude1

491
Modbus / Re: Arduino Modbus, Complete, Documented and free
« on: October 16, 2015, 08:06:18 PM »
look here http://forum.arduino.cc/index.php?topic=147680.0
the WProgram.h is from v1 of arduino it got changed to Arduino.h

493
Mach4 Videos / Re: Creating an M6 Toolchange in Mach4 (Part 1)
« on: October 07, 2015, 03:42:29 AM »
cool more info on \n for other`s
http://www.lua.org/pil/2.4.html

494
Mach4 Videos / Re: Creating an M6 Toolchange in Mach4 (Part 1)
« on: October 07, 2015, 03:24:49 AM »
 mc.mcCntlGcodeExecuteWait(inst,"G90 G53 G0 Z0.0 \n X260 \n Y50 ") can work the same as both Gcode lines, \n = wait to finished probably know that already

495
Modbus / Re: Arduino Modbus, Complete, Documented and free
« on: October 05, 2015, 03:38:19 PM »
there will be a need to change some bit`s of the code I cant rember what to long ago and ask on the arduino form

496
Modbus / Re: Arduino Modbus, Complete, Documented and free
« on: October 05, 2015, 01:25:36 AM »
update the usb driver`s also the modbus was written for a earlier version of arduino

have a look here it may help https://learn.adafruit.com/lesson-0-getting-started/installing-arduino-windows

497
you can do it with M4 http://gearotic.com/ESW/FavIcons/index.php?board=16.0 and it works

498
Mach4 General Discussion / Re: Mach4 PC/NB Min Spec
« on: September 28, 2015, 07:17:10 PM »
Mauri last time I ran M4 on a below speck computer using a large 3D file 691 KB it was fine 45 min run time and that was with a 250 mb graphics card with no graphics card it`s still running fine that`s a machine running M4 no siming.

when I tried M4 on my gaming laptop it was just as good, a half dead laptop it was fine, A acer pc it would not run and it was above minimum speck this is all connected to a machine and this computer ran M3 like a dog, all my other computer`s I tryed M3 or M4 with no problems.

why is this you ask they are not regular pc or work stations they are gameing computer`s why do I use gaming computer better than a regular pc/laptop cheaper and faster than a work station pc/laptop.

my main computer is a gaming laptop that run rings around faster and newer work station laptop with the same specks at $3000 less than a work station computer

499
Mach4 General Discussion / Re: Mach4 PC/NB Min Spec
« on: September 28, 2015, 05:10:39 PM »
then why can I run it fine on a below minum speck computer

500
Mach4 Toolbox / Re: Load GCode NO TOOLPATH
« on: September 28, 2015, 04:20:45 PM »
well done daz