Messages

461

Mach4 General Discussion / Re: No movement from ESS plugin

« on: October 29, 2015, 02:57:24 PM »

you still have ticks in m4 config you don't do this

and check your steps per

462

Mach4 General Discussion / Re: No movement from ESS plugin

« on: October 29, 2015, 02:54:04 PM »

you will have to do a table that gets activated by the estop you would have it in the PLC when estop is active do this

463

Mach4 General Discussion / Re: No movement from ESS plugin

« on: October 28, 2015, 06:10:05 PM »

Daz I keep forgetting to use the .ini it is faster than pick`s

464

Mach4 General Discussion / Re: No movement from ESS plugin

« on: October 28, 2015, 06:09:08 PM »

Cbyrdtopper what if any noise do the stepper motors make when you try to jog. you have the steps per set to a very oversize number with a slow as a wet week acc and velocity I think that may be a bit wrong

you have the EStop ticked in Mach config that's wrong you do it in the ESS config

465

Mach4 General Discussion / Re: Mach4 Printer Port Discussions

« on: October 27, 2015, 09:01:36 PM »

try starting as admin that does help, if you are going to run Darwin remove the sim plugs you don't needed them

466

Mach4 General Discussion / Re: Mach4 and Windows 10

« on: October 27, 2015, 08:59:06 PM »

it pays to run M4 as admin it clears some problems

467

Mach4 General Discussion / Re: Homing

« on: October 27, 2015, 08:26:35 PM »

no problem happy it is working for you

468

Mach4 General Discussion / Re: Homing

« on: October 27, 2015, 07:18:13 PM »

yep if you look at you pick you have X(0) what is X axis as motor 0, then you have it set as motor2 what is Z

then Y is correct with your slave as Motor0 what is the X axis

Z what is motor 2 you have it set as motor3 what is A axis

this is wrong you need to have everything set a certain way for the mapping to work other wise M4 will not work correctly at all

469

Mach4 General Discussion / Re: mcX360 Its Nearly Here

« on: October 27, 2015, 06:49:08 PM »

you a top man daz you need a pay rise

470

Mach4 General Discussion / Re: Homing

« on: October 27, 2015, 06:48:03 PM »

ok motor 0 is x, motor 1 is y, motor 2 is z and motor 4 is A what I take is your slave for a start

you have -- and ++ for home thats your limits not home you are confusing mach you need to watch the ESS set up vids