441
General Mach Discussion / Re: Control Panel Setup
« on: November 12, 2015, 04:54:28 AM »
you can make a encoder using a teensy they have a special library for it and keyboard and mouse emulation as well, or just get a pokeys board they are made for that sort of thing it would make life easier,
there are a tonne of ways to do what you want.
the easiest is with a modbus type system, PLC, pokeys or even easier a pendant, if you want to future proof your setup a contour Shuttle Pro v, vistacnc, xbox360 joystick or number pad are working pendants with M3 and M4 at this time and the pokeys pendant with a pokeys board is the same in M3 or M4
it down to your budget
there are a tonne of ways to do what you want.
the easiest is with a modbus type system, PLC, pokeys or even easier a pendant, if you want to future proof your setup a contour Shuttle Pro v, vistacnc, xbox360 joystick or number pad are working pendants with M3 and M4 at this time and the pokeys pendant with a pokeys board is the same in M3 or M4
it down to your budget