Hello Guest it is March 29, 2024, 07:14:00 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dude1

391
General Mach Discussion / Re: Mach 3 vs Mach 4
« on: December 20, 2015, 10:06:59 PM »
yer I was going well with my last xp computer to it got dropped 14 years old, everything is on 10 now it's as good as XP was, it's a good move if you have no choices in the matter other wise stay where you are XP is just ok with M4 as long as you don't have a nvidia GPU.

I am waiting for you boys to says it good as gold before I move to M4

392
General Mach Discussion / Re: Mach 3 vs Mach 4
« on: December 20, 2015, 03:29:24 PM »
That's the funny thing XP is meant to be dead and not supported any more but it still is

393
Mach4 General Discussion / Re: help with mach4 parallel port
« on: December 13, 2015, 05:39:47 PM »
yer It comes up with cant load 1024.set

394
Mach4 General Discussion / Re: help with mach4 parallel port
« on: December 13, 2015, 12:42:45 AM »
you need to put it in a zip file

395
Mach4 General Discussion / Re: help with mach4 parallel port
« on: December 13, 2015, 12:13:43 AM »
ok ronnierozier2 can I have that it would be faster than reading the ini file.

thanks steve

396
Mach4 General Discussion / Re: help with mach4 parallel port
« on: December 12, 2015, 11:59:15 PM »
C:\Mach4Hobby\Profiles

397
Mach4 General Discussion / Re: help with mach4 parallel port
« on: December 12, 2015, 11:46:47 PM »
post your .ini it's in you profile in c/mach4

398
Mach4 General Discussion / Re: Mach4 Printer Port Discussions
« on: December 12, 2015, 03:09:11 PM »
the plug in setting are the master settings, you map those signals to M4 in M4 you don't do anything to active high or low tick you leave that alone it will stuff it up, all you do is mappin enabled tick, device and input name or output name and don't touch active

399
Mach4 General Discussion / Re: Mach4 Install on XP
« on: December 11, 2015, 05:34:00 PM »
can you put it on line and run update's you may have something missing, and yes window update still works for xp

400
Mach4 General Discussion / Re: Mach4 Install on XP
« on: December 11, 2015, 04:23:54 PM »
do you start as admin