Hello Guest it is March 28, 2024, 06:18:06 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dude1

351
Mach4 General Discussion / Re: Adding external push buttons
« on: January 25, 2016, 11:14:17 PM »
in M4 you still have to map the controls sort of you can get the pokeys to do some of it, it's not that easy to do ( it crashes a lot so i gave up), as M3 is, that was plug and set steps vell and acc and that all I did with the 57CNC , I have there new one I am not sure if it's been released yet.

hossmachine use's a pokeys with M4 he has for quite sometime, look him up on youtube he has a control panel

352
Mach4 General Discussion / Re: Adding external push buttons
« on: January 25, 2016, 03:56:07 PM »
dont know I only have a 57cnc what is so hard to get going that all you have to do is plug it in, it is just as easy in M3 plug it in and that's about all.

you can use the pokeys boards as IO only

you would have to ask the pokeys boy about the 56u

353
Mach4 General Discussion / Re: Adding external push buttons
« on: January 25, 2016, 01:46:40 PM »
you can do the same thing with a pokeys what is good to go with M3 and M4 have a look at the 57cnc or the 57 E or U

354
Mach4 General Discussion / Re: Adding external push buttons
« on: January 25, 2016, 03:26:01 AM »
Machmotion are using M4 (look up there youtube channel) they will be waiting for it to get more stable, if you ask for a M3 controller they will help then

355
Mach4 General Discussion / Re: Adding external push buttons
« on: January 24, 2016, 08:12:22 PM »
Brains is a M3 thing M4 use's a different method 

356
Mach4 General Discussion / Re: Adding external push buttons
« on: January 24, 2016, 08:11:12 PM »
have a look in the scripting manual , what daz posted above can be change to input what ever, call what ever one after the other in a table. just play and post back when you need help.

I think the manual is a bit out you will have to check with Daz on this one

357
Mach4 General Discussion / Re: Adding external push buttons
« on: January 22, 2016, 08:50:53 PM »
you can do it with a script just find Daz and ask him

358
Mach4 General Discussion / Re: M06 not working
« on: January 21, 2016, 04:31:53 PM »
C:\Mach4Hobby\Profiles\Mach4Mill\Macros

359
Mach4 General Discussion / Re: M06 not working
« on: January 21, 2016, 04:13:00 PM »
make sure the M6 macro starts with M not m

360
Mach4 General Discussion / Re: Backlash not applied during manual JOG?
« on: January 21, 2016, 01:32:03 PM »
that's nasa speck