Messages

331

General Mach Discussion / Re: How does feed hold work when using a smooth stepper? Is it delayed?

« on: February 22, 2016, 12:05:13 AM »

in M3 it's the end of the line of code it's on

332

Mach4 General Discussion / Re: Mach4 with ESS and PMDX126/107 speed control issues.

« on: February 21, 2016, 10:28:22 PM »

looking at the 107 manual you have the pins select as it's says to do and set in the ESS config.

in M4 config select spindle on as your pwm pin 16 and spindle forward as the on off pin 14.

bob and Steve you sell a board that connects to a ESS why don't you know how to set it up. and should the op be using it with M4. if I am out off line asking this question sorry but product support is your name and word

333

Mach4 General Discussion / Re: Mach4 with ESS and PMDX126/107 speed control issues.

« on: February 21, 2016, 09:57:39 PM »

as far as i know that's how its done a OB motor for the spindle it's like that with Darwin, if its wrong for OP set up speck up
 the OB are motors 6 to 9

334

Mach4 General Discussion / Re: Mach4 with ESS and PMDX126/107 speed control issues.

« on: February 21, 2016, 05:38:43 PM »

give a a couple of hours I will do a quick vid

335

Mach4 General Discussion / Re: Mach4 with ESS and PMDX126/107 speed control issues.

« on: February 21, 2016, 01:57:32 PM »

OB stands for out of band you just tick it in motors then in axis mapping you tick it then in the spindle setup you put what OB motor it is you don't set anything for it any where else.

then in your outputs you set the pin's

don't over think it

336

Mach4 General Discussion / Re: Mach4 with ESS and PMDX126/107 speed control issues.

« on: February 20, 2016, 02:43:26 PM »

there is a new M4 ESS plug coming out soon, weeks if not days

337

Mach4 General Discussion / Re: Mach4 with ESS and PMDX126/107 speed control issues.

« on: February 20, 2016, 02:42:09 PM »

you don't tick the active low in mach at all leave it alone, leave the red X yes the motor should show in the motor tab's use a OB motor Steve will come back with the M4 info

338

Mach4 General Discussion / Re: Mach4 with ESS and PMDX126/107 speed control issues.

« on: February 20, 2016, 02:38:15 PM »

Steve M4

339

General Mach Discussion / pokeys and G540

« on: February 20, 2016, 03:29:32 AM »

has anyone got a G540 working with a Pokeys 57CNC v1.2 and a superpid I am having a hell of a time getting the 57CNC to control the superpid

340

Mach4 General Discussion / Re: Mach4 2803, ESS, and homing slaved motors

« on: February 19, 2016, 07:20:08 PM »

thanks daz