Messages

271

General Mach Discussion / Re: Weird rotary axis issue???????????????

« on: April 27, 2016, 03:47:24 PM »

Taraks have a look here some idea's for you to try http://warp9td.com/index.php/kunena/7-general-discussion/5586-ess-buffer?start=6

272

General Mach Discussion / Re: Weird rotary axis issue???????????????

« on: April 27, 2016, 05:54:44 AM »

I do hit stop, feed hold in M3 is ok for the times when there is no problems, but when there is na I wont use it.

when Mach 4 is working better and the ESS plug is finished it'S at 85% they just have to do the changes when M4 is changed and get the probing working, the feed hold problem is no more.

Andy will be getting back to me soon I have asked if they can have a look at this thread to see if they can work out what is wrong, what my be the buffer over flowing when Taraks runs the Axis more than one turn, and making the machine crash hard, what could trip the machine.

has profile .XML would help

273

General Mach Discussion / Re: Weird rotary axis issue???????????????

« on: April 27, 2016, 01:37:46 AM »

yer yer Rodger not arguing never would with you.

 
Taraks screen set I can't see a feed hold button that's why I am asking about the cycle stop button, and ask about if there is a way to make feed hold work faster on the ESS forum I would like to know that one my self with my big router at fall wack feed hold is well I don't like to use it a half inch router bit goes everywhere if it crashes and I hit feed hold it does not stop fast enough, for some reason I have to have a big buffer.

274

General Mach Discussion / Re: Weird rotary axis issue???????????????

« on: April 27, 2016, 01:19:35 AM »

with the stop button it should just stop what code did you use with your cycle stop button

275

General Mach Discussion / Re: Weird rotary axis issue???????????????

« on: April 27, 2016, 01:17:50 AM »

I have asked the ESS guys about it should hear back in a few hours

276

General Mach Discussion / Re: Weird rotary axis issue???????????????

« on: April 26, 2016, 10:30:15 PM »

as far as I know it's down to the buffer size on the ESS smaller faster bugger slower, that was from the horse mouth

277

Show"N"Tell ( Your Machines) / Re: Lagun KneeMill Mach4 Pokeys Retrofit

« on: April 26, 2016, 09:46:20 PM »

once you have the table done it should be ok, you just need Daz to check it if does not work they made a change to how it is done

278

General Mach Discussion / Re: Weird rotary axis issue???????????????

« on: April 26, 2016, 09:43:44 PM »

feedhold stops when the buffer has run out of info in Mach3, Mach4 it works when you hit it

279

PoKeys / Re: Pokeys57E,Mach4 External Push Button

« on: April 26, 2016, 07:52:10 PM »

there is a Mach4 programming manual in the manual folder in the Mach4 folder on your C drive

you will have to make a table

280

General Mach Discussion / Re: Weird rotary axis issue???????????????

« on: April 25, 2016, 09:22:06 PM »

Tarak reply 7 is for you