Messages

241

Mach4 General Discussion / Re: Mach4 Printer Port Discussions

« on: May 10, 2016, 05:42:55 PM »

pin states is high or low what you don't set in M4

242

Mach4 General Discussion / Re: Hanging up on a M03 after installing version 2.2914 ??

« on: May 10, 2016, 05:08:02 PM »

Pedio you should have started your own thread, it makes it easier to help, and always post your ini or profile

243

Mach4 General Discussion / Re: Mach4 Printer Port Discussions

« on: May 10, 2016, 05:06:20 PM »

Kvom do you have any pin states set in M4

244

PoKeys / Re: Pokeys57E Mach3 Win10 64bit

« on: May 09, 2016, 07:58:47 AM »

I ran it on a win 10 laptop with no problems, after I stuffed the set up a few time's and was able to just reset the pokeys I had the latest .net

245

General Mach Discussion / Re: Weird rotary axis issue???????????????

« on: May 09, 2016, 01:04:24 AM »

that's better that's where I would like my big router to be at all the time but it's big so 0.01 to 0.00 over 1000 movements on a single axis is good, I just have to keep it at 1250 mm/min any faster it's moving out by mm at a time in any direction. but it's a easy fix $1200 worth of new parts it came from bad advise years ago lesson learnt only listen to experienced users that have a good name on here not the others.

246

General Mach Discussion / Re: Weird rotary axis issue???????????????

« on: May 09, 2016, 12:40:21 AM »

my 3D printer use's GT2 pulleys and belts and it's quite good at 5000 mm/min

247

General Mach Discussion / Re: Weird rotary axis issue???????????????

« on: May 09, 2016, 12:12:41 AM »

yer you did if it works it works

248

General Mach Discussion / Re: Weird rotary axis issue???????????????

« on: May 08, 2016, 10:24:37 PM »

that's still does not look quite correct I think you may have a bug in Mach3 are those the one's you did in gearotic

249

HiCON Motion Controller / Re: MACH4 Turn, HiCON Integra, Gecko G320's, ADC GS2 VFD on Hardinge HNC Lathe

« on: May 07, 2016, 11:24:27 PM »

well done

250

General Mach Discussion / Re: Weird rotary axis issue???????????????

« on: May 06, 2016, 09:43:13 PM »

files..