Hello Guest it is March 28, 2024, 07:47:46 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dude1

231
General Mach Discussion / Re: Bridgeport Knee Mill Conversion?
« on: May 25, 2016, 06:41:00 AM »
shielded is good just have the shield connected at one end only going to your common 

232
it's as Tweakie Said parallel port needs a 32 bit computer up to win 7. 8 and up needs a external controller

233
General Mach Discussion / Re: Bridgeport Knee Mill Conversion?
« on: May 17, 2016, 06:29:06 AM »
can be both you can tye it into the door as well if it has one

234
General Mach Discussion / Re: Bridgeport Knee Mill Conversion?
« on: May 17, 2016, 06:12:02 AM »
if it can rip your arm off all safety stuff should be done

235
General Mach Discussion / Re: Bridgeport Knee Mill Conversion?
« on: May 17, 2016, 05:41:56 AM »
with Mach3 you can have all limits on one input same with home, it just you don't know what limit is hit unless you can see what one is, you can also have home and limits as the same switch, but it a good idea to have home and limits, limits can be cheap switches. home switches for accuracy spend the money

236
not everyone understands what Art did let alone Microsoft

237
Mach3 is a 32 bit only with the  p port external controllers what ever they take

238
General Mach Discussion / Re: Fusion 360 and mach3
« on: May 12, 2016, 03:43:18 PM »
the latest update has a tonne of bugs in it I found two all new bugs last night so I need to posted it on the fusion forum

239
General Mach Discussion / Re: confused and pissed
« on: May 11, 2016, 01:38:21 AM »
good idea

240
General Mach Discussion / Re: confused and pissed
« on: May 10, 2016, 10:07:13 PM »
those boards are known to be not so good, look up on cnczone all bad storys