Messages

221

Mach4 General Discussion / Re: Using Modules

« on: May 29, 2016, 06:55:43 PM »

http://www.machsupport.com/forum/index.php/topic,27572.0.html

222

Mach4 General Discussion / Re: Using Modules

« on: May 29, 2016, 06:24:46 PM »

have a look back to the last page on the M4 post have a look at what popperbear did

223

General Mach Discussion / Re: Keen to learn mild steel with my CNC router!!

« on: May 29, 2016, 06:31:08 AM »

if you have a router spindle good luck

Regards From the Mainland 

224

Mach4 General Discussion / Re: Mach4 how to use M62 P0 Command to control Output 0

« on: May 29, 2016, 04:14:34 AM »

ESS diag page

225

General Mach Discussion / Re: Bridgeport Knee Mill Conversion?

« on: May 27, 2016, 07:21:15 AM »

the enable not the power if i turn the bob of it turns the driver enable off, it's probley wrong, I have had some bad advice in the past any way I like hoods idea

226

General Mach Discussion / Re: Bridgeport Knee Mill Conversion?

« on: May 27, 2016, 07:07:51 AM »

nc same here but was told off for killing the power to the drivers and the controller, the bob I use and drivers both have a enable so killing that was what I was told was safer, no inrush, no signal no motion.

everyone has different ideas

Explain please, my terminology....

Controller - CSMIO  yes
Drive - the servo amplifier units  yes 
Motor - the servo motor itself   yes

227

General Mach Discussion / Re: Bridgeport Knee Mill Conversion?

« on: May 27, 2016, 06:49:23 AM »

yes
yes
yes

correct

228

Mach4 General Discussion / Re: Writing to machine.ini

« on: May 27, 2016, 05:05:49 AM »

4.4 in the scripting manual

229

General Mach Discussion / Re: Bridgeport Knee Mill Conversion?

« on: May 27, 2016, 05:03:03 AM »

you should have it drop the power to the controller killing the power to the motor may course back current

230

General Mach Discussion / Re: Bridgeport Knee Mill Conversion?

« on: May 25, 2016, 03:50:18 PM »

I have heard of people saying they are going to do this but never do