Hello Guest it is March 28, 2024, 10:19:57 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dude1

161
PoKeys / Re: PoKeys57CNC vs SmoothStepper
« on: September 25, 2016, 03:40:41 PM »
the 57cnc you just connect up it's plug and go oc1 -oc5  the step pin is the 3rd in from bottom left

162
General Mach Discussion / Re: Does this product exist?
« on: September 22, 2016, 02:28:55 AM »
what code are you using there is one out there that does crash if the home and work is under 25mm diffrences

163
General Mach Discussion / Re: Bridgeport Knee Mill Conversion?
« on: September 12, 2016, 03:35:44 PM »
the keep it very professional

164
General Mach Discussion / Re: Bridgeport Knee Mill Conversion?
« on: September 12, 2016, 03:18:17 PM »
Dave post on the fusion forum the EE will say how to do it

165
PoKeys / Re: PWM Settings for Pokeys57CNC
« on: September 12, 2016, 03:28:07 AM »
are you using the ethernet cable or USB, I have different hardware I use pin 20 for pwm. pin 17 would not work as it should on the G540 when I first set it up, there is a reason for it. that was the only problem I have had with it, but they responded straight away on the support ticket within 24 hours. what's good as they are 14 hours in my past

other than that just try pin 20

166
PoKeys / Re: PWM Settings for Pokeys57CNC
« on: September 12, 2016, 02:48:15 AM »
I have one it works fine, any problems they fix with in 24 hours if they can reproduce them. there are other factors that can make things go wrong

167
Mach4 General Discussion / Re: Mach4 Keyboard Emulation
« on: September 06, 2016, 08:28:07 PM »
mc.mcCntlCycleStart(inst) have a look at the scripting manual and the mach4 core api

168
PoKeys / Re: PoKeys57CNC vs SmoothStepper
« on: September 02, 2016, 04:16:40 AM »
57CNC it's a bit ahead of the ESS

169
Mach4 General Discussion / Re: Mach 4 V2 Windows 10
« on: August 22, 2016, 03:43:19 PM »
you can only disable win 10 updates on pro not home

170
General Mach Discussion / Re: Bridgeport Knee Mill Conversion?
« on: August 18, 2016, 02:31:40 AM »
 it would be quite easy to do in fusion then it gives you the high speed cutting it is a lot faster cutting with fusion than vectric products but not as easy to use