Messages

1251

FAQs / Re: help needed with emco pc mill rebuild

« on: September 02, 2011, 08:43:58 PM »

will do a silly question will steeper motors work as in rotate if wired wrong

1252

FAQs / Re: help needed with emco pc mill rebuild

« on: September 01, 2011, 09:29:13 PM »

i have got z and y axis move in one direction only put x axis in y axis to test if it works it does.
only z, y working x not working
if cannot get working will take borad out and shoot it these boards are a pain in the ass

1253

FAQs / help needed with emco pc mill rebuild

« on: August 31, 2011, 08:15:39 PM »

im triing to re build a emco pc mill30 have up graded the drive board with one of those cheap 4 axis tb6560 boards the instructions are up the wopwop are not correct the only part of the instructions that where correct was for the limmit swithes.
i will be runnining it on mach 3 need help with ports and pins
and not to shaw on the wireing of the stepper motors as dont have any info on them and cant find any info on them they are step super type 103g770-2249 they are 3v 2a 1.8 deg/step can any one help with this