Topics

31

Mach3 under Vista / mach 3 /win 7

« on: December 30, 2011, 06:52:30 PM »

is there going to be a mach3 put out that will run under win 7 64 bit as about to start bulding a new machine would like to run it on a new computer ie win 7

32

General Mach Discussion / superpid control under mach3

« on: October 02, 2011, 09:52:10 PM »

does anyone now what config to use for the superpid running mach3 through a g540
can get spindle to turn on and off but cannot seem to change the speed of the spindle in mach 3 help please

33

FAQs / help needed with emco pc mill rebuild

« on: August 31, 2011, 08:15:39 PM »

im triing to re build a emco pc mill30 have up graded the drive board with one of those cheap 4 axis tb6560 boards the instructions are up the wopwop are not correct the only part of the instructions that where correct was for the limmit swithes.
i will be runnining it on mach 3 need help with ports and pins
and not to shaw on the wireing of the stepper motors as dont have any info on them and cant find any info on them they are step super type 103g770-2249 they are 3v 2a 1.8 deg/step can any one help with this