Topics

1

General Mach Discussion / using a spindle encoder w/ Mach 3

« on: January 17, 2008, 01:48:21 PM »

 I have an older DOS-based cnc lathe that I'm looking to upgrade to Mach 3 using my existing g100/mach3 setup. The lathe uses a KVM style spindle motor controller and so I was planning on using the digispeed XL board, however, the spindle uses an encoder (see attached image) and I'm trying to find out how I might be able to take advantage of the existing encoder arrangement by configuring mach rather than swapping it out for a pulse generating indexer, etc...

 Can this be accomplished with the g100 and mach combined or can mach even be configured to at all to take advantage of a spindle encoder like this one?

 Thanks!!

2

Mach3 and G-Rex / G100 not compatible 100mbits/s cable ports?

« on: December 23, 2007, 08:56:18 PM »

 Does anyone happen to know if the G100 is compatible with 100Base-T cable ports? I can get the Grex Loader to find the g100 on my main pc that has a built-in 10/100Base ethernet but I can't seem to get it to work on my 100Base pc.

 I tried running the G100.m3p w/ each of the filies added to the mach3 dir separately (3720 for 10Base and 3750 for 100Base) but it doesn't seem to make a difference for me.

 I am able to ping the grex successfully however I am unable to locate it with the Grex-Loader.

 Any ideas?