Guest
Show Posts
1
General Mach Discussion / Mach3 Mill
« on: August 13, 2011, 01:57:45 AM »
i facing a problem during homing process :-
current setting is :
a. Auto Zero disable
b. with Galil PCI motion card , all axis homing is OK - turn to yellow when active (M1 Home, M2 Home and M3 Home)
during homing ,Z Axis will doing homing first , the Z Axis will move up untill Home Sensor Triggered and it move down , it continuously mov down
although Home sesnor already OFF untill hit the limit , Why ? any setting wrong ?
current setting is :
a. Auto Zero disable
b. with Galil PCI motion card , all axis homing is OK - turn to yellow when active (M1 Home, M2 Home and M3 Home)
during homing ,Z Axis will doing homing first , the Z Axis will move up untill Home Sensor Triggered and it move down , it continuously mov down
although Home sesnor already OFF untill hit the limit , Why ? any setting wrong ?