Hello Guest it is September 20, 2019, 04:32:08 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - first off

Pages: « 1 2 3
21
General Mach Discussion / New system....servo are running rough.
« on: August 08, 2011, 10:56:56 PM »
Hey guys.
It has been a long time since I have needed help from the Mach Guru's but I have a problem that has me stumped.
I have just put together a new system using a referbed Del gx620 which has an on board parallel port. I have tuned the servo's. When I jog any of the servo's they run rough. I tried using a PCI parallel port also and i got the same result. After I tried swapping the components I yanked my PC from my system and plugged it in and the servo's ran perfectly smooth. Any idea's why the Del is causing the servo's to run rough? Thanks for your help.
Russ. 

Pages: « 1 2 3