Hello Guest it is December 08, 2021, 02:28:38 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ipc150

Pages: 1
1
General Mach Discussion / mach3 foam cutter heat control.
« on: March 04, 2012, 03:25:27 AM »
I'm korean user mach3. I'm not good at english. I hope you understand my question.
I control heat by dial. very Often i change dial so i cannot choose exact volume.
I hope to control heat by mach3 (use spilndle control)

Do i need any other equipment? (ex. converter ,inverter, ??)

2
LazyCam (Beta) / Re: Lazy cam setup
« on: August 05, 2011, 11:25:32 PM »
hi. i'm korean LC, mach3 user.

i think i have similar problem.

i made lazy cam design. two layer exist. inside and outside.

when i load mach3. mach3 doen't draw indide cut.(for example ABC , A's inside, B's inside)

how can i solve this problem.


Pages: 1