1
General Mach Discussion / Some questions about radius compensation
« on: September 19, 2008, 05:01:31 PM »
Im trying my luck at milling a 30mm diameter 15mm deep pocket and ran into some troubles using radius compensation.
This is my code
g0 z5
g41 D6
g0 x30 y47
g0 z1
g3 x30 y47 i0 j3 z-1 f300
g3 x30 y47 i0 j3 z-1
g3 x30 y42 i0 j3
g3 x30 y37 i0 j8
g3 x30 y35.1 i0 j13
g3 x30 y35.1 i0 j14.9
g3 x30 y35.1 i0 j14.9 z-2
g3 x30 y37 i0 j14.9
g3 x30 y42 i0 j13
g3 x30 y47 i0 j8
g3 x30 y47 i0 j3 z-2
g40
as you can see im using z moves while in g41 is this not allowed?
This is my code
g0 z5
g41 D6
g0 x30 y47
g0 z1
g3 x30 y47 i0 j3 z-1 f300
g3 x30 y47 i0 j3 z-1
g3 x30 y42 i0 j3
g3 x30 y37 i0 j8
g3 x30 y35.1 i0 j13
g3 x30 y35.1 i0 j14.9
g3 x30 y35.1 i0 j14.9 z-2
g3 x30 y37 i0 j14.9
g3 x30 y42 i0 j13
g3 x30 y47 i0 j8
g3 x30 y47 i0 j3 z-2
g40
as you can see im using z moves while in g41 is this not allowed?