Hello Guest it is January 19, 2022, 05:56:18 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - boumac

Pages: 1
FAQs / Re: Newbie needs Mach3 setup help for New CNC Plasma setup
« on: April 22, 2012, 07:46:06 PM »
I'm looking for help with this as well.

FAQs / Re: Using mach plasma control
« on: April 22, 2012, 07:39:43 PM »
Hey I'm with you.  Need to know how house it.

FAQs / Re: Jogging problem Z+ and Z- always goes UP
« on: April 22, 2012, 07:26:13 PM »
Yes I had the same issue.  Thought I was going crazy.  Reinstallation worked

General Mach Discussion / Trouble with Z axis
« on: April 08, 2012, 04:31:27 PM »
I'm a newbie.  Just getting my plasma table up and running.  Bought it used and made some improvements.  Upgraded from Mach 2 to Mach 3.  If I choose plasma icon from my desktop I can jog X and Y but not Z.  Display shows Z is moving but it isn't.  Checked output pins etc. all good. If I plug Z cable into Y or X it runs fine.  If I open Mach 3 Mill from the desktop icon all axes work well.  Wondering if I need to download an d reinstall?????

Pages: 1