Hello Guest it is March 29, 2024, 07:29:03 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - rene

Pages: 1
1
General Mach Discussion / Re: Stepper Motor problem
« on: July 17, 2011, 09:55:21 AM »
Hi Tweakie

I did the test that you told me to do and sometime Z Axis is moving but always in the same direction is moving down never up

Rene

2
General Mach Discussion / Re: Stepper Motor problem
« on: July 17, 2011, 08:47:11 AM »
Thanks for the quick answer

René

3
General Mach Discussion / Re: Stepper Motor problem
« on: July 17, 2011, 08:27:26 AM »
Hi tweakie

Thanks for your comments
I will check those setting. Could you tell me if 320 steps per units is ok with a 5 mm pitch ball screw

Rene

4
General Mach Discussion / Stepper Motor problem
« on: July 16, 2011, 06:35:11 PM »
Hello to everyone
I have builted my first CNC router  and I tried to setup my Z axis with Mach3 motor tuning and I have only nose or vibration with the Z motor
The X - Y axis is running very well

    1 M254 NEMA23 Stepper Motors  Z axis
    2 M637 NEMA34 Stepper Motors  X - Y axis
    1 Micro Step Drivers D42 4.2 AMP, 50VDC  Z axis
    2 Micro Step Drivers D56 5.6 AMP, 50VDC  x - Y axis

I am connected directly to my ball screw 5 MM pitch

Hope somebody can help me

Thanks


Pages: 1