Hello Guest it is April 17, 2024, 12:32:45 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - sawcnc

Pages: « 1 2
11
General Mach Discussion / Re: Total newb - Inspiron 560s
« on: July 07, 2011, 09:31:25 AM »
Thanks Bloy. I guess all I need is the comp, the card, 32 bit Windows  and Mach3 and I am good to go.
BTW, love the Yin Yang.

12
General Mach Discussion / Total newb - Inspiron 560s
« on: July 06, 2011, 11:22:50 AM »
I am building Joe's hybrid 4x4 with the R&P mod. I am using the Gecko G540 4 axis stepper motor driver with Nema 23 380 oz-in stepper motors.

I am planning on buying the Dell Inspiron 560s to run Mach3. Are there any problems with that computer? Can someone recommend a parallel port adapter for the PCI slot? Is there anything else I need?  I will be getting the 32 bit version of windows.


Thanks

Pages: « 1 2