Messages

81

General Mach Discussion / Current Hi/Lo setting?

« on: August 02, 2011, 04:40:33 PM »

I'm confused with the Current Hi/Lo setting in the Output Sign as configuration.  I think I'm right in saying that it can limit current to the motors until actually required, which assists in keeping them cool?

The bit I'm confused about is what pin do I assign it to and where does it go!  Does it only relate to driver boards that have a specific function to reduce the motor's current and have an appropriate pin?

Apologies if it's a stupid question!

Keith

82

Machscreen Screen Designer / Re: Border properties

« on: July 27, 2011, 04:49:55 PM »

Thanks Klaus.  Perfect!

Keith

83

Machscreen Screen Designer / Border properties

« on: July 27, 2011, 08:57:28 AM »

As a relative newcomer to Mach3, I was wondering if the raised border around the G-Code window and Toolpath, and the
inset border around the DRO's could be removed.  In other words, I require just a plain border (or preferably, no boarder at all)
Is this possible?