Messages

11

Mach3 under Vista / Re: Touch off sequence not completing. Urgent help required!

« on: May 24, 2018, 07:04:18 AM »

Legacy custom screen

12

Mach3 under Vista / Re: Touch off sequence not completing. Urgent help required!

« on: May 24, 2018, 06:17:40 AM »

Can someone tell me if the file that controls the touch off sequence is in the Macro folder, plug=ins or where? If this file does not exist what controls the touch off and where can it be found?

13

Mach3 under Vista / Re: Touch off sequence not completing. Urgent help required!

« on: May 23, 2018, 01:52:41 PM »

Yes it worked until recently. I got a guy at Legacy to fix a problem with the driver using TeamViewer. Everything seemed OK until I tried a touch off. The backup I have all worked as well. It seems like its a configure issue within Mach - but then I know very little about it.

14

Mach3 under Vista / Re: Touch off sequence not completing. Urgent help required!

« on: May 23, 2018, 01:28:50 PM »

Thanks for replying
Tried the .xml from several backups and same thing with all.

15

Mach3 under Vista / Touch off sequence not completing. Urgent help required!

« on: May 23, 2018, 12:40:33 PM »

Hi List
I am running a Legacy CNC router with Mach3 on Win7. My issue is that when I run the program to perform a touch off on the pad the Z axis drops down to touch off, lift off a few millimetres and starts down slowly again to touch off the pad. The activation light comes on and the tol stops. However, nothing else happens - it won't finish the cycle. Any ideas why? I have tried replacing the Macros folder from a good backup to no avail. I am stumped and in dire need of this machine. Please help!

Regards

16

Mach3 under Vista / Re: Mach3 not controlling motors

« on: May 15, 2018, 03:21:54 PM »

Mach Directory is in C drive.

17

Mach3 under Vista / Re: Mach3 not controlling motors

« on: May 15, 2018, 02:54:16 PM »

Yeah. Got as far as the end where it says Driver installed.

18

Mach3 under Vista / Re: Mach3 not controlling motors

« on: May 15, 2018, 02:42:38 PM »

Hi Craig
I mentioned in an earlier email that when I do that Mach does not ask me which controller I want to use - it asks me what program I want to open .

19

Mach3 under Vista / Re: Mach3 not controlling motors

« on: May 15, 2018, 02:29:01 PM »

Sorry Craig
Dont know how to do either

20

Mach3 under Vista / Re: Mach3 not controlling motors

« on: May 15, 2018, 05:43:18 AM »

Hi Craig
The reason I double clicked it was because I was following the instruction. When double clicked it should install itself in the correct folder. I have it in the Plugins folder but still nothing.