21
General Mach Discussion / 4 axis Job Display problem
« on: November 19, 2012, 01:31:19 PM »
Friday I was doing some engraving on a 4 axis mill, with the rotary head oriented along the x axis.Been doing this for a couple of years now. No problem. I noticed that the Job Display was actually showing the engraving in the right orientation, ie around the part. This was the first time it had done this! Usually it just shows some jumbled lines in x and y. I loaded another program Saturday and it went back to the jumbled lines. How do I turn this feature on so that I see the toolpath rotated around the part?
thanks
i_r_
thanks
i_r_