Hello Guest it is January 24, 2022, 09:50:02 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - FredduMoi

Pages: 1
General Mach Discussion / Weird stalling... :(
« on: June 06, 2011, 12:30:34 PM »

I have a 4 axis TB6560 driver board and 4 motors.
The X axis has another motor slaved.
Everything works except that the Y axis is stalling horribly!
and if I remove the slaved motor from the system, every motor starts stalling.
It's the same situation if i put the slaved motor on the Y axis, then the X axis won't work.
There has been no problems with the Z axis except for when not having the slaved motor in the system.
The PC should be able to make it.. 2.8GHz Pentium 4 and a 128mb graphics ard.
The driver test came up OK.

Pages: 1