Hello Guest it is March 28, 2024, 09:20:20 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - FredduMoi

Pages: 1
1
General Mach Discussion / Re: Weird stalling... :(
« on: June 07, 2011, 12:59:53 PM »
blue chinese TB6560 driver board
wiring and motors seem to be fine.. because it works with every motor except for the X or Y axis' motor when it has not got a slaved motor..if every motor is on its own then all of them except the Z axis motor stalls...
the power supply is 24v and 14A

XML: http://pastebay.com/125369

2
General Mach Discussion / Weird stalling... :(
« on: June 06, 2011, 12:30:34 PM »
Hi

I have a 4 axis TB6560 driver board and 4 motors.
The X axis has another motor slaved.
Everything works except that the Y axis is stalling horribly!
and if I remove the slaved motor from the system, every motor starts stalling.
It's the same situation if i put the slaved motor on the Y axis, then the X axis won't work.
There has been no problems with the Z axis except for when not having the slaved motor in the system.
The PC should be able to make it.. 2.8GHz Pentium 4 and a 128mb graphics ard.
The driver test came up OK.

Pages: 1