1
General Mach Discussion / Mach3 Ignores Feedrates In G Code
« on: February 07, 2012, 10:09:18 AM »
Hi,
Mach3 ignores the feed rates in my g code unless I change the "S" in the spindle DRO from 0 to 1. The problem is that I can't figure out how to save it at 1 and I have to reset it by hand every time I open Mach3. It is getting tiresome. Any ideas? Thank you.
RS
Mach3 ignores the feed rates in my g code unless I change the "S" in the spindle DRO from 0 to 1. The problem is that I can't figure out how to save it at 1 and I have to reset it by hand every time I open Mach3. It is getting tiresome. Any ideas? Thank you.
RS