Guest
Show Posts
11
General Mach Discussion / Stepper motor with ball screws
« on: June 04, 2011, 09:54:37 AM »
Hi everyone!
Is this calculation correct? I have just finished my mini mill cnc conversion with Mach 3 software. The stepper motor is a Nema 23 with 311 oz. with a driver board set to 10 micro steps.
The stepper cal is 2000, the velocity set to 600, what should the step and dir pulse be? The drive systems is belt drive (due to space limits ), the motor has a 16 teeth gear. the ball screw has 32 teeth gear. The ball screw is a Nook .631 with a .200 lead (single start). Should the stepper cal remain at 2000 or changed to 20000?
Thanks to everyone.
air2gnd
Is this calculation correct? I have just finished my mini mill cnc conversion with Mach 3 software. The stepper motor is a Nema 23 with 311 oz. with a driver board set to 10 micro steps.
The stepper cal is 2000, the velocity set to 600, what should the step and dir pulse be? The drive systems is belt drive (due to space limits ), the motor has a 16 teeth gear. the ball screw has 32 teeth gear. The ball screw is a Nook .631 with a .200 lead (single start). Should the stepper cal remain at 2000 or changed to 20000?
Thanks to everyone.
air2gnd