1
Feature Requests / Re: Manual Spindle Calibration *PLEASE*
« on: June 23, 2011, 12:56:39 AM »
No you cannot. If everything was linear the yes. But nothing is.
They really need to put in a proper calibration system.
Like you it increments the PWM up 5% and asks you to enter the RPM.
It continues that all the way up to 100%.
Then it builds a proper relationship between RPM and PWM.
Such a simple feature, I cannot believe it has not been implemented!
They really need to put in a proper calibration system.
Like you it increments the PWM up 5% and asks you to enter the RPM.
It continues that all the way up to 100%.
Then it builds a proper relationship between RPM and PWM.
Such a simple feature, I cannot believe it has not been implemented!