Messages

11

General Mach Discussion / part size in tool path

« on: April 30, 2012, 11:06:57 PM »

How do you change the part size in the tool path display?I am just learning and I have some tool paths where the part is very small and some where its of the screen.Thanks.

12

VB and the development of wizards / Re: I am having trouble with loading the engraving wizard

« on: April 22, 2012, 08:15:41 PM »

Its strange I have run the simulations many times and they worked.I am going to spend some time on it tomorrow morning.I will do a step by step so maybe we can see what I have done wrong.Thanks Dave.

13

VB and the development of wizards / I am having trouble with loading the engraving wizard

« on: April 19, 2012, 12:57:35 PM »

I can not get the engraving wizard that comes in mach to load code to my run screen?Before I had my mill on line I could get it to run a simulation but now that I have my machine on line I cant get it to load any g code.What am I doing wrong?THANKS Dave.

14

General Mach Discussion / Re: 1st time build having problems spinning motors!

« on: November 21, 2011, 08:09:42 PM »

I hate to sound dumb but whays a xml file?Iam a rookie guys I NEED HELP!

15

General Mach Discussion / 1st time build having problems spinning motors!

« on: November 20, 2011, 01:21:03 AM »

I need help!I have a kelig 3 axis system and mach3.I wired it as in the attachment and set mach 3 with the set up guide.The motors have power as they cant be spun by hand.But when I try to jog the software runs the dro but the motors stay.Can someone set me in the right direction.Thanks Macatoms.