301
General Mach Discussion / Re: lathe -g28 moves x before z
« on: April 14, 2012, 11:18:51 AM »
thnaks overloaded and tp
(Using mach3 turn on lathe with the standard screen)
I opted to try the G0 X0 option and this is what i did
( I used a .tap that i wrote called turndownod.tap)
After swirching on I used home switches to "set home X"" and "set home Z"
I jogged the x until it took a cut .
I measured the cut and entered that value into the X axis dro in top left of screen.
I touched the face with the tool tip and zeroed the Z axis at that position
i went to auto prep screen and loaded my turndownod.tap
(I had previously put this line in first
G30 X0 ( in your suggestion))
I did a single cycle and when it got to that line it rapid ran the tool to
X0 when I had wanted it to go to x home
What did i do wrong ? ( apart from breaking the tooltip ( LOL )
regards
fred
(Using mach3 turn on lathe with the standard screen)
I opted to try the G0 X0 option and this is what i did
( I used a .tap that i wrote called turndownod.tap)
After swirching on I used home switches to "set home X"" and "set home Z"
I jogged the x until it took a cut .
I measured the cut and entered that value into the X axis dro in top left of screen.
I touched the face with the tool tip and zeroed the Z axis at that position
i went to auto prep screen and loaded my turndownod.tap
(I had previously put this line in first
G30 X0 ( in your suggestion))
I did a single cycle and when it got to that line it rapid ran the tool to
X0 when I had wanted it to go to x home
What did i do wrong ? ( apart from breaking the tooltip ( LOL )
regards
fred