Messages

231

General Mach Discussion / Re: block delete control

« on: November 01, 2012, 05:44:02 AM »

sorry chaps - i didnt know that "locked topic" wont allow posting of replies--
( I thought it meant " the topic will be locked on my screen "

sorry about that - I have unlocked it so please reply

fred

232

General Mach Discussion / Re: block delete control

« on: October 31, 2012, 06:33:19 AM »

Thanks Klaus for that-

I am using 1024.lset-- turning and there is no block delete button

What is the command in gcode to turn on or to turn off the block delete mode

thanks

fred

233

General Mach Discussion / Re: scripter compile error ( 2 questions)

« on: October 12, 2012, 02:26:10 PM »

ah ha thanks

fred

234

General Mach Discussion / Re: scripter compile error ( 2 questions)

« on: October 10, 2012, 03:53:50 AM »

Thanks Hood-
where is this macro and what is ir called?
I have searched for *.mis and get no result?
regards
fred

235

General Mach Discussion / scripter compile error ( 2 questions)

« on: October 08, 2012, 05:44:31 AM »

Hi chaps
I am getting an error " scripter compile error in spindle speed.mis"
Could someone tell me what is wrong?
second question - where can i get a list of Mach3 error codes?

regards

fred evans

236

General Mach Discussion / Re: setup1,setup2,setup3??

« on: October 08, 2012, 04:27:13 AM »

sure thing - unless they are relics from some previous installations
but they can stay -
best regards

fred

237

General Mach Discussion / Re: setup1,setup2,setup3??

« on: October 07, 2012, 02:20:17 PM »

so what are these files??

fred

238

General Mach Discussion / Re: setup1,setup2,setup3??

« on: October 05, 2012, 03:16:37 AM »

Just a routine disk rearrangement and cleanup--

i regularly go through my various computers and weed out the rubbish
It is comforting to know that i am only keeping nessessary stuff
and not backing up a lot of unnessessary files.

regards
fred

239

General Mach Discussion / setup1,setup2,setup3??

« on: October 04, 2012, 05:27:06 AM »

Hi chaps,
in the mach3 folder there are folders named setup1 and setup 2 etc.
what are these ? can they be deleted?

best regards
fred

240

General Mach Discussion / Re: set feedrate mode G94 and g95

« on: October 01, 2012, 12:33:27 PM »

thanks very much hood

regards

fred