Messages

21

Share Your GCode / Re: Dragon GCode

« on: July 24, 2011, 11:13:32 PM »

 sorry 2 to 4 mm every line toward _ x axis

22

Share Your GCode / Re: Dragon GCode

« on: July 24, 2011, 11:12:28 PM »

 started to read lines g code the x is to the minus side every line 2 to 4every line mike

23

Share Your GCode / Re: Dragon GCode

« on: July 24, 2011, 11:06:38 PM »

   scale  0.9000 same as when i set it

24

Share Your GCode / Re: Dragon GCode

« on: July 24, 2011, 11:05:35 PM »

 scale on program run is the same  as when i set it

25

Share Your GCode / Re: Dragon GCode

« on: July 24, 2011, 11:04:00 PM »

i have not change anything on  my cnc  beside raised z axis

26

Share Your GCode / Re: Dragon GCode

« on: July 24, 2011, 11:00:37 PM »

 not very good on g codes yet what would i be looking for  and can i fix this

27

Share Your GCode / Re: Dragon GCode

« on: July 24, 2011, 10:58:21 PM »

 I am glade i i put 2x 8 ft sheet of mdf and said im just going to practise on this half sheet
until it is all cut to pieces . because it is starting to look like junk.
mikee

28

Share Your GCode / Re: Dragon GCode

« on: July 24, 2011, 10:50:37 PM »

  hey graham it was like i changed the off sets in the middle of the file
  i have rewind several times to set z plunge bepth at the first of the file i did the by zero my z axis dro not by changing g codes .
mike
 

29

Share Your GCode / Re: Dragon GCode

« on: July 24, 2011, 10:38:13 PM »

hey Graham
 i did what you said at first it was doing
then my cnc kept going _x _x untill it hit my limits about 250mm -x
mike

30

Share Your GCode / Re: Dragon GCode

« on: July 24, 2011, 08:51:49 PM »

thank you so much  Graham i will try this.
 
mikee