Messages

1

General Mach Discussion / Re: Help w/ cnc plasma issue

« on: May 03, 2011, 12:33:53 PM »

I believe it is arc start

2

General Mach Discussion / Re: Help w/ cnc plasma issue

« on: May 03, 2011, 12:31:07 PM »

Mind of it's own = torch head shuts off, move -y until limit switch. Totally aborts the intended cut path. As for HF noise, plasma and computers are on separate power panels, no wires were touching the plasma line.

3

General Mach Discussion / Help w/ cnc plasma issue

« on: May 01, 2011, 11:20:27 PM »

Having some issues I am hoping you all can help. I am running my software on a cnc plasma. If I run the g code without the plasma it runs clean. The minute I run with the torch the machine takes on a mind of it's own. However if I run without the torch, and manually fire it mid code it runs flawlessly? Could this be an ground/noise issue? Controller is a c and cnc unit.