Messages

21

Mach4 General Discussion / G 93 code

« on: August 24, 2021, 09:18:19 AM »

Attached is a file that i converted with a G93 converter program . It adds separate feed rates for the A axis, when i run it in Mach 4.2.0.4612 , the A axis runs at the file feed rate , not at a separate rate for "A" .Does something have to be changed in Mach 4  , for it to recognize G93 code??

    Thanks

       Ed

22

Mach4 General Discussion / Re: M6 Script Problem

« on: January 02, 2021, 01:20:40 PM »

Brian , i was able to create a button called tool change in the jogging panel . How do i add your M6 script it it , i did not see that in the example video .

     Thanks   Edcross

23

Mach4 General Discussion / Re: M6 Script Problem

« on: January 02, 2021, 08:37:22 AM »

Brian , is there a video on how to insert a button on the mach4 screen ?

24

Mach4 General Discussion / Re: M6 Script Problem

« on: December 31, 2020, 04:37:44 PM »

Mach4 v 4300 , vcarve desktop pro v 10.5  , PP attached , script from newfangled video on youtube.com - using Mach2/3 atc inch pp from vcarve attached . Can you help edcross

25

Mach4 General Discussion / New Mach4 hobby simulator

« on: May 08, 2020, 02:01:23 PM »

Anyone using the new beta mach4 simulator , have a question on how to setup cnc table to match cutting file .

     Thanks

       Ed

26

Mach4 General Discussion / Re: Vcarve

« on: May 01, 2020, 09:32:39 AM »

It will not reset until you close mach 4 and unplug/plugin smartbob

   Ed

27

Mach4 General Discussion / Vcarve

« on: April 30, 2020, 04:27:23 PM »

Anyone have trouble with vcarve desktop v10 and mach 4 v 4300 with PMDX 411 smartbob , ERROR = cannot communicate with device.

    Ed

28

Mach4 Plugins / Re: Stupid Vista Plug in, S and V reversed

« on: April 02, 2020, 11:14:56 AM »

I have a p 4-s and when i jog from it any axis it will trip mach 4 v 4300 error code motion underrun 7, reset and it may work a couple times , then faults again . Wrote to zista but no reply yet .

29

Third party software and hardware support forums. / pmdx 411 w gecko g540 control with mach 4

« on: May 09, 2019, 02:26:29 PM »

I want to turn on output #5 on gecko g540 control through Mach4 . Which pin should i use in the pmcx 411 , do i need to set up spindle parms ??

     Ed

30

Mach4 General Discussion / Mach4 axis

« on: May 19, 2017, 03:35:22 PM »

How can I change Z to X in Mach 4  Lathe