1
Post Processors / Mach3 postprocessor for Mastercam X6
« on: December 21, 2011, 04:32:00 AM »
Hi,
DO you have postprocessor gor mastercam X6 please ?
Thanks !
DO you have postprocessor gor mastercam X6 please ?
Thanks !
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
For example, if your Y axis is tilted to the right by 0.003"/inch, you could enter a formula like this:
X = X - (Y * 0.003)
Y = Y
On a "straight" machine, when you tell Mach3 to move from Y0.000 to Y1.000, Y will move 1.000", and X will not move at all. On this hypothetical crooked machine, that same move will cause Y to move 1.000", but X will also move to the right, off-true, by 0.003", due to the error in the machine. Entering the above formula un-does this error. So, now when you command a move from Y0.000 to Y1.000, Mach will actually do a two-axis move, from X0.000, Y0.000 to X-0.003, Y1.000, "un-doing" the error in the machine.