Messages

11

General Mach Discussion / Re: halfmoon instead of circle

« on: May 03, 2011, 06:36:06 PM »

The common on the bob is set for 5v but when z moves up the voltage at common goes to 2.85.

The plasma breaker has not been turned on for over a week.

12

General Mach Discussion / Re: halfmoon instead of circle

« on: May 03, 2011, 05:16:29 PM »

did my z before quitting  here are the results  Z only moves in the -  refuses to move up

direction in z-  is 4.96v and stays at that untill it is set to move up and then it measures 0 and stays

pulse stays at 4.96 either way

common is 4.96 for z-  and 2.85 for z+

13

General Mach Discussion / Re: halfmoon instead of circle

« on: May 03, 2011, 04:56:22 PM »

and yes I will do each one seperatly tomorrow and find out the results

14

General Mach Discussion / Re: halfmoon instead of circle

« on: May 03, 2011, 04:54:32 PM »

it's texas micro circuits, or sound logic. 

15

General Mach Discussion / Re: halfmoon instead of circle

« on: May 03, 2011, 04:34:37 PM »

In the picture it shows them close together but I did seperate them several days ago.  Just the commanded shows movement.

16

General Mach Discussion / Re: halfmoon instead of circle

« on: May 03, 2011, 01:30:51 PM »

The only thing not done is bypassing the bob (sick and tired of wiring).  There is no induction with the wires.

17

General Mach Discussion / Re: halfmoon instead of circle

« on: May 03, 2011, 12:09:46 PM »

ok all the unshielded wire has been replaced with absolutely no change to how it's been reacting.
 

18

General Mach Discussion / Re: halfmoon instead of circle

« on: May 03, 2011, 08:09:54 AM »

Ok but this is the last time I'm rewiring this pos. 

19

General Mach Discussion / Re: halfmoon instead of circle

« on: May 03, 2011, 07:37:59 AM »

Where would I be getting the noise from?  The plasma's breaker is still shut off.

20

General Mach Discussion / Re: halfmoon instead of circle

« on: May 02, 2011, 05:32:06 PM »

2 days with an automation tech here and still no further then I was when I originally installed everything.  One major problem is that we have 2 different pin settings, one from the company I bought this off of and one from Texas micro circuits.  They are a little different, but it seems like neither one is correct for the board.  I can go into pins and ports, and change nothing, but click ok and I get different responces from my axis then the time before.  some times one axis will control different 2 axis at once, until I play with them for a bit then they seem to work themselves out, but then I go back to my y not moving until my x moves. 

I'm almost ready to start bashing heads.