1
General Mach Discussion / Mach 3 Blue screen probing
« on: December 29, 2012, 03:40:22 PM »
Posted problem in probing did not get a anything back.
I have loaded the Mach blue screen probing, the feed rate defaults to 4 units per min this is too slow, I have looked at the VB script but this is not driven from the script, it is looking at feed rate DRO (818) when I change it on the settings screen it does not retain the value of the DRO the script is coded to retrieve from.
Where should I enter the feed rate to lock it down. Everwhere I have tried to enter it then run the macro it still goes back to 4.
Any help would be good or any tips to fix it and get it working, it is beating me up.
Thanks.
I have loaded the Mach blue screen probing, the feed rate defaults to 4 units per min this is too slow, I have looked at the VB script but this is not driven from the script, it is looking at feed rate DRO (818) when I change it on the settings screen it does not retain the value of the DRO the script is coded to retrieve from.
Where should I enter the feed rate to lock it down. Everwhere I have tried to enter it then run the macro it still goes back to 4.
Any help would be good or any tips to fix it and get it working, it is beating me up.
Thanks.